Poe Configuration - D-Link DGS-3130 Series Web Ui Reference Manual

DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured for PoE Status are described below:
Parameter
Unit
From Port - To Port
Description
Click the Apply button to accept the changes made.
Click the Delete Description button to remove the description from the entry.

PoE Configuration

This window is used to display and configure the PoE configuration settings.
NOTE: If the Switch failed to supply power to the IEEE 802.3at Powered Device (PD),
• Check if the PD connected to the port supports the IEEE 802.3at standard
• Manually configure the PoE power limit value to 30 Watts for the corresponding port
To view the following window, click System > PoE > PoE Configuration, as shown below:
The fields that can be configured for PoE Configuration are described below:
Parameter
Unit
From Port - To Port
Figure 3-123 PoE Status Window
Description
Select the stacking unit ID of the Switch that will be configured here.
Select the appropriate port range used for the configuration here.
Enter the text that describes the PD connected to a PoE interface. The
maximum length is 32 characters.
Figure 3-134 PoE Configuration Window
Description
Select the stacking unit ID of the Switch that will be configured here.
Select the appropriate port range used for the configuration here.
17