Specifying The Sampling Start And End Conditions - Omron ZW-XC7 User Manual

Specifying the sampling start and end conditions

You can specify the conditions for starting and ending sampling.
1
Check the Trigger start conditions/Trigger end conditions checkbox.
2
Select the trigger condition.
Item
Trend setting
146
Displaying measured values in graphs
Setting item Range
Trigger start I/O
conditions
Data slope
Data window (In)
Data window (Out)
Trigger end I/O
conditions
Data slope
Data window (In)
Data window (Out)
Number of data
Description
Specify parallel I/O
Specify parallel I/O: written the belows, as the trigger
condition.
Parallel I/O are specified as the trigger condition the
following:
TIMING, ZERO, BUSY, ENABLE, HIGH, PASS, LOW,
TASKSTAT, LOGGING, LOGSTAT, LOGERR, STABILIT as
the trigger condition.
Sets the change in the measured values for Out1 to Out4
as the start condition. Sets the trigger level. When the
measured value rises above this value or falls below it, the
start trigger is issued.
Sets the change in the measured values for Out1 to Out4
as the start condition. When the measured value is inside
the range, the start trigger is issued.
Sets the change in the measured values for Out1 to Out4
as the start condition. When the measured value is outside
the range, the start trigger is issued.
Specify parallel I/O (TIMING, ZERO, BUSY, ENABLE,
HIGH, PASS, LOW, SYNC/TRIG, SYNCFLG,
TASK_ENABLE, LOGGING, LOGSTAT, LOGERR,
STABILITY RESET,BUFFER_ERROR) as the trigger
condition.
Sets the change in the measured values for Out1 to Out4
as the start condition. Sets the trigger level. When the
measured value rises above this value or falls below it, the
end trigger is issued.
Sets the change in the measured values for Out1 to Out4
as the start condition. When the measured value is in the
range, the end trigger is issued.
Sets the change in the measured values for Out1 to Out4
as the start condition. When the measured value is outside
the range, the end trigger is issued.
The sampling data is counted from when the start
condition is met and when the specified number of data
points have been sampled, the end trigger is issued.
ZW-7000 User's Manual