GE Senographe 2000 D Operator's Manual page 153

GE Healthcare
REV 1
Message
Msg.
on Column
Source
No.
Readout
I28 GEN None
I29 GEN None
I31 GEN None
I32 GEN None
I33 GEN None
I34 GEN None
I46 GEN None
I50 GAN Lock
Jammed
I51 GAN Hot Lock
I52 GAN Arm
Unlocked
I54 GAN Wait...
Message on
Explanation
Control Console
Max wait for It is necessary to wait
same exposure the displayed time to
mn be able to repeat the
same exposure.
Excessive mAs The amount of mAs
for this mode necessary to repeat
mAs the same exposure is
too high in the mode
Abort: Image
signal too low
Abort: Image
signal too high
Abort: No AOP
zone found
Thickness out of
AOP range
System Setting in AWS set-up in
progress progress (loading of
Flat Field map) after a
new filter was
Lock Jammed LOCK PROBLEM:
In spite of command,
lock release does not
Lock Overheated Lock temperature too
high (used for too long
period and/or too
Tube Housing Tube housing arm in
Arm Unlocked unstable position
because lock is badly
Power Limitation Heat protection for 27
V supply. Elevator,
rotation, and light
centering device lock
are blocked.
151
Senographe 2000 D Acquisition System
Wait the required amount of time to
repeat exposure. If an exposure is
attempted before this time, an abort
may possibly occur (there is a safety
margin to ensure proper operation).
You can ignore the message if a
different, less dense, breast is to be
imaged next.
Switch to a different mode or to a
different filter.
selected.
No action required.
This message is displayed for two
seconds after selection of a new
filter.
selected.
Try again to release lock.
If the problem continues, note ALL
messages and contact GEMS Field
operate. Service.
Wait for lock to cool.
frequently)
Pivot arm to latch correctly.
If the problem continues, note ALL
messages and contact GEMS Field
latched. Service.
Leave equipment idle for a while.
If the problem continues, note ALL
messages and contact GEMS Field
Service.
OM 5179217–1–100
Corrective Action