Aimer Delay
The aimer delay allows a delay time for the operator to aim the scanner before the bar code is read. Use these codes to set the
time between when the button is pressed and when the bar code is read. During the delay time, the aiming light will appear, but
the LEDs won't turn on until the delay time is over. Default = Off.
200 milliseconds
* Off (no delay)
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the bar code below, then set the time-out by scanning
digits (0 - 4,000 ms) from the
Aimer Mode
This feature allows you to turn the aimer on and off. When the Interlaced bar code is scanned, the aimer is interlaced with the
illumination LEDs. Default = Interlaced.
Off
Centering
Use Centering to narrow the scanner's field of view to make sure that when the scanner is hand-held, it reads only those bar
codes intended by the user. For instance, if multiple codes are placed closely together, centering will insure that only the
desired codes are read. (Centering can be used in conjunction with
in applications where multiple codes are spaced closely together. Using the Aimer Delay and Centering features, the scanner
can emulate the operation of older systems, such as linear laser bar code scanners.)
If a bar code is not touched by a predefined window, it will not be decoded or output by the scanner. If centering is turned on by
scanning Centering On, the scanner only reads codes that pass through the centering window you specify using the Top of
Centering Window, Bottom of Centering Window, Left, and Right of Centering Window bar codes.
4 - 12
Programming Chart
inside the back cover of this manual, then scan Save.
Delay Duration
Aimer
Delay, page 4-12, for the most error-free operation
400 milliseconds
* Interlaced