Plug Removal; Figure 17: Pulling The Pull Tab; Figure 18: Removing The Plug Without Tools; Figure 19: Removing The Plug Using A Screwdriver - WAGO 753-482 Manual

44 Mounting
5.3.2

Plug Removal

1. Remove the plug from the I/O module by pulling the orange pull tab on the
plug toward the top of the I/O module.

Figure 17: Pulling the Pull Tab

The plug detaches from the I/O module.

Figure 18: Removing the Plug Without Tools

2. Alternatively, you can also use a standard screwdriver at the position
shown (in the figure below) to remove the plug.

Figure 19: Removing the Plug Using a Screwdriver

Manual
Version 1.2.0
WAGO I/O System 750
753-482 2AI 4-20mA 12 Bit S.E. HART