Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
10) Press as to select [STORE], and press the <ENTER> button.
f The confirmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
Note
f For limitation of the character string that can be set as a password, refer to "[PASSWORD POLICY]" (x page 78).
f Pressing the <MENU> button while the [ADMINISTRATOR ACCOUNT] screen is displayed enables to advance to the next operation
without setting the password of the administrator account but network function of the projector will not be able to be used. When using the
web control function or the communication control via LAN (including operation by application software), set a password.
f When pressing the <MENU> button while the [ADMINISTRATOR ACCOUNT] screen is displayed, the [ADMINISTRATOR ACCOUNT]
screen will not be displayed from the next time the projector is switched on. To use the network function, set a password in the [NETWORK]
menu → [ADMINISTRATOR ACCOUNT].
f The user name and password of the administrator account can also be changed in "[Set up password] page (when accessed by
administrator account)" (x page 258) of the web control screen.
f The user name and password of the standard user account without administrator rights can be set in "[Set up password] page (when
accessed by administrator account)" (x page 258) of the web control screen.
Making adjustments and selections
It is recommended to perform the focus adjustment after 30 minutes have elapsed with the focus test pattern
displayed. For details of the test pattern, refer to "[TEST PATTERN] menu" (x page 205). To use the active focus
optimizer function, set the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OPTIMIZER] → [ACTIVE
FOCUS] to [ON], and then adjust the focus. (x page 171)
1)
Press the <FOCUS> button to roughly adjust the focus of the projected image. (x page 83)
Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
2)
installation mode. (x page 42)
f Refer to "Navigating through the menu" (x page 100) for the operation of the menu screen.
3)
Set [LENS TYPE].
f Confirm the setting of the lens type when using the projector for the first time after attaching the projection
lens. (x page 86)
4)
Execute the lens calibration.
f Execute the lens calibration when using the projector for the first time after attaching the projection lens.
(x page 87)
5)
Select the input by pressing the input selection button on the remote control or the control panel.
f The buttons that can be used on the remote control or the control panel are as follows.
Remote control:
<HDMI> button, <DISPLAYPORT> button, <DVI-D> button, <SDI> button, <DIGITAL LINK> button,
<SLOT 1> button, <SLOT 2> button
Control panel:
<HDMI> button, <DIGITAL LINK> button, <SLOT 1> button, <SLOT 2> button
f For details of operation for input selection, refer to "Selecting the input signal" (x page 81).
6)
Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 57)
7)
Press the <SHIFT> button to adjust the position of the projected image.
5)
6)
2) 3) 4)
1) 7) 8) 9) 10)
1) 9)
ENGLISH - 79
5)
2) 3) 4)
7)
8) 10)
Advertisement
Table of Contents
