Table of Contents
Advertisement
Projector body
Front
1 2
3 4
5
6
Rear
8
8
Bottom
Projection direction
1
Remote control signal receiver (front)
2
Power indicator <ON (G)/STANDBY (R)>
Indicates the status of the power.
Attention
f Do not block the intake/exhaust vents of the projector.
Note
f The optional NFC Upgrade Kit (Model No.: ET-NUK10) can be used to enable the NFC function of the projector. Note that there are some
models that have the NFC function enabled from the time of factory shipment, and there are some countries or regions where the NFC
Upgrade Kit cannot be applied.
For the availability of the NFC function in the country or region where you purchased the product, visit the Panasonic website (https://
panasonic.net/cns/projector/) or consult your dealer.
Chapter 1 Preparation — About your projector
Side
5
7
8
6
14
6
9
10
3
Light source indicator <LIGHT>
Indicates the status of the light source.
4
Temperature indicator <TEMP>
Indicates the internal temperature status.
5
Adjustable feet
Adjusts the projection angle.
6
Intake vent
7
Remote control signal receiver (rear)
8
Exhaust vent
9
Control panel (x page 34)
10 Connecting terminals (x page 35)
11 NFC touch point
This is the touch point when using the near field communication
(NFC, Near Field Communication) function. A device such as a
smartphone equipped with the NFC function can be connected
to the projector by holding it near the touch point.
12 <AC IN> terminal
Connect the supplied power cord.
13 <MAIN POWER> switch
Turns on/off the main power.
14 Security bar
A wire, etc., can be attached to prevent theft.
6
11
12 13
ENGLISH - 33
Advertisement
Table of Contents
