Table of Contents
Advertisement
Setting [BIT DEPTH] in [SLOT IN] (SDI input)
Press as to select [SLOT IN].
1)
2)
Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
Press as to select [SINGLE LINK SETTING], [DUAL LINK SETTING], or [QUAD LINK SETTING], and
3)
press the <ENTER> button.
f The [SINGLE LINK SETTING] screen, the [DUAL LINK SETTING] screen, or the [QUAD LINK SETTING]
screen is displayed.
f Proceed to Step 5) when [DUAL LINK SETTING] or [QUAD LINK SETTING] is selected.
Press as to select [SDI1], [SDI2], [SDI3], or [SDI4], and press the <ENTER> button.
4)
f The [SINGLE LINK SETTING] screen for the selected item is displayed.
Press as to select [BIT DEPTH].
5)
Press qw to switch the item.
6)
f The items will switch each time you press the button.
[AUTO]
[12-bit]
[10-bit]
Setting [SIGNAL LEVEL] in [SLOT IN] (SDI input)
Press as to select [SLOT IN].
1)
2)
Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
Press as to select [SINGLE LINK SETTING], [DUAL LINK SETTING], or [QUAD LINK SETTING], and
3)
press the <ENTER> button.
f The [SINGLE LINK SETTING] screen, the [DUAL LINK SETTING] screen, or the [QUAD LINK SETTING]
screen is displayed.
f Proceed to Step 5) when [DUAL LINK SETTING] or [QUAD LINK SETTING] is selected.
Press as to select [SDI1], [SDI2], [SDI3], or [SDI4], and press the <ENTER> button.
4)
f The [SINGLE LINK SETTING] screen for the selected item is displayed.
Press as to select [SIGNAL LEVEL].
5)
Press qw to switch the item.
6)
f The items will switch each time you press the button.
[64-940]
[4-1019]
When the optional Interface Board for 12G-SDI Optical (Model No.: ET-MDNFB10) is installed
Set this item according to the input and output signals when this Interface Board is installed in the slot.
Setting [SDI OPT 1/2 OUT] in [SLOT IN] (OPT input)
Set whether or not to output the signal from the <SDI OPT 1/2 OUT> terminal.
Press as to select [SLOT IN].
1)
2)
Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
Press as to select [SDI OPT 1/2 OUT].
3)
154 - ENGLISH
Chapter 4 Settings — [DISPLAY OPTION] menu
Automatically selects [12-bit] or [10-bit].
Fixes to [12-bit].
Fixes to [10-bit].
Normally use this setting.
Select this item when gray is displayed as black.
Advertisement
Table of Contents
