Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
f The user name and password of the administrator account can also be changed in "[Set up password] page (when accessed by
administrator account)" (x page 210) of the web control screen.
f The user name and password of the standard user account without administrator rights can be set in "[Set up password] page (when
accessed by administrator account)" (x page 210) of the web control screen.
Making adjustments and selections
Perform the image adjustment when the projected image has stabilized.
When the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OPTIMIZER] → [ACTIVE FOCUS] is
set to [OFF], it is recommended to perform the focus adjustment after 30 minutes or more have elapsed with the
focus test pattern displayed. For details of the test pattern, refer to "[TEST PATTERN] menu" (x page 155).
To use the active focus optimizer function, set the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS
OPTIMIZER] → [ACTIVE FOCUS] to [ON], and then adjust the focus.
For details of [ACTIVE FOCUS OPTIMIZER], refer to the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE
FOCUS OPTIMIZER] (x page 129).
1)
Press the <FOCUS> button to roughly adjust the focus of the projected image. (x page 68)
2)
Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 36)
f Refer to "Navigating through the menu" (x page 79) for the operation of the menu screen.
3)
Execute the lens calibration.
f Execute the lens calibration when using the projector for the first time after attaching the projection lens.
(x page 70)
4)
Select the input by pressing the input selection button on the remote control or the control panel.
f The buttons that can be used on the remote control or the control panel are as follows.
Remote control:
<HDMI 1> button, <HDMI 2> button, <DIGITAL LINK> button, <SDI> button, <INPUT MENU> button
Control panel:
<INPUT SELECT> button
f For details of operation for input selection, refer to "Selecting the input signal" (x page 67).
5)
Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 44)
6)
Press the <SHIFT> button to adjust the position of the projected image.
7)
Press the <ZOOM> button to adjust the image size to match the screen.
8)
Press the <FOCUS> button again to adjust the focus.
9)
Press the <ZOOM> button again to adjust the zoom to match the projected image size to the screen.
Note
f When the projector is switched on for the first time after purchase, or when the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY
RESET] is executed, the focus adjustment screen is displayed after the projection starts, followed by the [INITIAL SETTING] screen and
the [ADMINISTRATOR ACCOUNT] screen. If the [PROJECTOR SETUP] menu → [INITIALIZE] → [NETWORK/E-MAIL ONLY] is executed,
the [ADMINISTRATOR ACCOUNT] screen is displayed after the projection starts. For details, refer to "When the initial setting screen is
displayed" (x page 57) and "When the administrator account setting screen is displayed" (x page 63).
2) 3)
5)
1) 8)
4)
1) 6) 7) 8) 9)
ENGLISH - 65
6)
7) 9)
2) 3)
4)
Advertisement
Table of Contents
