Table of Contents
Advertisement
Setting [EDID MODE] in [SLOT IN] (DisplayPort input)
Press as to select [SLOT IN].
1)
2)
Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
Press as to select [DisplayPort1], [DisplayPort2], [DisplayPort3], or [DisplayPort4], and press the
3)
<ENTER> button.
f The [DisplayPort1] screen, the [DisplayPort2] screen, the [DisplayPort3] screen, or the [DisplayPort4]
screen is displayed.
Press as to select [EDID MODE].
4)
5)
Press the <ENTER> button.
f The [DisplayPort EDID MODE] screen is displayed.
Press qw to switch the item.
6)
f The items will switch each time you press the button.
[DEFAULT]
[USER]
f Proceed to Step 11) when [DEFAULT] is selected.
7)
Press the <ENTER> button.
f The [RESOLUTION] screen is displayed.
Press asqw to select [RESOLUTION].
8)
f Select [1024x768p], [1280x720p], [1280x800p], [1400x1050p], [1600x900p], [1600x1200p], [1920x1080p],
[1920x1200p], [2048x1080p], [2560x1600p], or [3840x2400p].
9)
Press the <ENTER> button.
f The [VERTICAL SCAN FREQUENCY] screen is displayed.
10) Press qw to select [VERTICAL SCAN FREQUENCY].
f Select [60Hz], [50Hz], or [30Hz] when [3840x2400p] is selected for [RESOLUTION].
f Select [60Hz], [50Hz], [30Hz], [25Hz], or [24Hz] when [2048x1080p] is selected for [RESOLUTION].
f Select [120Hz], [60Hz], [50Hz], [30Hz], [25Hz], or [24Hz] when [1920x1080p] is selected for
[RESOLUTION].
f Select [60Hz] or [50Hz] when anything other than following is selected for [RESOLUTION].
g [3840x2400p], [2048x1080p], [1920x1080p]
11) Press the <ENTER> button.
f The confirmation screen is displayed.
12) Press qw to select [OK], and press the <ENTER> button.
Note
f The settings in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] are displayed in [EDID STATUS].
f The resolution and vertical scanning frequency settings may also be required on your computer or video device.
f The computer, video device, or projector in use may require the power to be turned off and on again after configuring settings.
f A signal may not be output with the resolution and vertical scanning frequency that have been set, depending on your computer or video
device.
When the optional Interface Board for 12G-SDI (Model No.: ET-MDN12G10) is installed
Setting [SDI MODE] in [SLOT IN] (SDI input)
Switch input/output of the <SDI 2 IN/1 OUT> terminal and the <SDI 4 IN/3 OUT> terminal.
Press as to select [SLOT IN].
1)
2)
Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
150 - ENGLISH
Chapter 4 Settings — [DISPLAY OPTION] menu
Standard setting.
Sets the [RESOLUTION] and [VERTICAL SCAN FREQUENCY] items to EDID.
Advertisement
Table of Contents
