Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
f When pressing the <MENU> button while the [ADMINISTRATOR ACCOUNT] screen is displayed, the [ADMINISTRATOR ACCOUNT]
screen will not be displayed from the next time the projector is switched on. To use the network function, set a password in the [NETWORK]
menu → [ADMINISTRATOR ACCOUNT].
f The user name and password of the administrator account can also be changed in "[Set up password] page (when accessed by
administrator account)" (x page 250) of the web control screen.
f The user name and password of the standard user account without administrator rights can be set in "[Set up password] page (when
accessed by administrator account)" (x page 250) of the web control screen.
Making adjustments and selections
Perform the image adjustment when the projected image has stabilized.
It is recommended to perform the focus adjustment after 30 minutes have elapsed with the focus test pattern
displayed. For details of the test pattern, refer to "[TEST PATTERN] menu" (x page 192).
1)
Press the <FOCUS> button to roughly adjust the focus of the projected image. (x page 82)
2)
Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 42)
f Refer to "Navigating through the menu" (x page 91) for the operation of the menu screen.
3)
Execute the lens calibration.
f Execute the lens calibration when using the projector for the first time after attaching the projection lens.
(x page 156)
4)
Select the input by pressing the input selection button on the remote control or the control panel.
f The buttons that can be used on the remote control or the control panel are as follows.
Remote control:
<HDMI 1> button, <HDMI 2> button, <DISPLAYPORT> button, <SLOT> button
Control panel:
<HDMI 1/2> button, <DISPLAYPORT> button, <SLOT> button
f For details of operation for input selection, refer to "Selecting the input signal" (x page 80).
5)
Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 50)
6)
Press the <SHIFT> button to adjust the position of the projected image.
7)
Press the <ZOOM> button to match the projected image size to the screen.
8)
Press the <FOCUS> button again to adjust the focus.
9)
Press the <ZOOM> button again to adjust the zoom and match the projected image size to the screen.
Note
f When the projector is switched on for the first time after purchase, or when the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY
RESET] is executed, the focus adjustment screen is displayed after the projection starts, followed by the [INITIAL SETTING] screen and
the [ADMINISTRATOR ACCOUNT] screen. If the [PROJECTOR SETUP] menu → [INITIALIZE] → [NETWORK/E-MAIL ONLY] is executed,
the [ADMINISTRATOR ACCOUNT] screen is displayed after the projection starts. For details, refer to "When the initial setting screen is
displayed" (x page 71), "When the administrator account setting screen is displayed" (x page 76).
78 - ENGLISH
2) 3)
5)
4)
4)
1) 6) 7) 8) 9)
6)
1) 8)
7) 9)
2) 3)
4)
Advertisement
Table of Contents
