Table of Contents
Advertisement
Chapter 5 Operations — Using the information monitor function
4)
Press the <ENTER> button.
f The network selection item is displayed.
Press as to select [WIRED LAN].
5)
6)
Press the <ENTER> button.
f The detailed setting item is displayed.
Press as to select [DHCP].
7)
f The current setting is displayed.
8)
Press the <ENTER> button.
f Setting can be changed.
Press qw to switch the setting item.
9)
f The items will switch each time you press the button.
[ON]
[OFF]
Note
f This setting item is common with the following menu item in the on-screen menu.
g The [NETWORK] menu → [WIRED LAN] → [DHCP]
r Specifying the wired LAN IP address
Set the IP address, the subnet mask, and the default gateway if a DHCP is not used.
Press as to select [SETUP].
1)
2)
Press the <ENTER> button.
f The sub-menu item is displayed.
Press as to select [NETWORK].
3)
4)
Press the <ENTER> button.
f The network selection item is displayed.
Press as to select [WIRED LAN].
5)
6)
Press the <ENTER> button.
f The detailed setting item is displayed.
Press as to select [IP ADDRESS], [SUBNET MASK], or [DEFAULT GATEWAY].
7)
f The current setting is displayed.
8)
Press the <ENTER> button.
f Setting can be changed.
Press asqw to enter the address.
9)
f Press qw to select the number to change, and press as to change the number.
10) Press the <ENTER> button.
f The setting is reflected.
Note
f This setting item is common with the following menu item in the on-screen menu.
g The [NETWORK] menu → [WIRED LAN] → [IP ADDRESS]/[SUBNET MASK]/[DEFAULT GATEWAY]
f The number can be entered with the number (<0> - <9>) buttons on the remote control when the projector is in the standby status.
268 - ENGLISH
Acquires the IP address automatically if a DHCP server exists in the network where the projector is to
be connected.
Set [IP ADDRESS], [SUBNET MASK], and [DEFAULT GATEWAY] if a DHCP server does not exist in
the network where the projector is to be connected.
Advertisement
Table of Contents
