Table of Contents
Advertisement
f If you press asqw to select [CANCEL] and then press the <ENTER> button, the lens memory will not be
saved.
f If you press asqw to select [DEFAULT] and press the <ENTER> button, the entered name will not be
registered and the default name will be used.
f If you select [OK] without entering any characters and press the <ENTER> button, the default name will be
used.
Note
f The numeric value information of the zoom position is displayed only in following cases.
g When the standard DC motor unit installed in the Zoom Lens (Model No.: ET-D75LE6, ET-D75LE8, ET-D75LE10, ET-D75LE20,
ET-D75LE30, ET-D75LE40, etc.) is replaced with the stepping motor unit using the Stepping Motor Kit (Model No.: ET-D75MKS10)
g When the Zoom Lens with the stepping motor (Model No.: ET-D3LEW60, ET-D3LET80, ET-D3LEW10, ET-D3LES20, etc.) is attached
Loading the lens position
Press as to select [LENS].
1)
2)
Press the <ENTER> button.
f The [LENS] screen is displayed.
Press as to select [LENS MEMORY].
3)
4)
Press the <ENTER> button.
f The [LENS MEMORY] screen is displayed.
Press as to select [LENS MEMORY LOAD].
5)
6)
Press the <ENTER> button.
f The [LENS MEMORY LOAD] screen is displayed.
f The name of the saved lens memory and its lens position information ([VERTICAL POSITION]/
[HORIZONTAL POSITION]/[FOCUS POSITION]/[ZOOM POSITION]) are displayed in the [LENS MEMORY
LOAD] screen.
Press as to select the item to load, and press the <ENTER> button.
7)
f The confirmation screen is displayed.
Press qw to select [OK], and press the <ENTER> button.
8)
f The lens will automatically move to the lens position (vertical position, horizontal position, focus position,
and zoom position) of the loaded lens memory.
Note
f Lens memory is not guaranteed to be 100 % reproduced. Readjust the focus, zoom, and lens shift after loading the lens memory if required.
f If the projection lens is replaced, execute the [PROJECTOR SETUP] menu → [LENS] → [LENS CALIBRATION], readjust the focus, zoom,
and lens shift, and save the lens memory again.
f The lens memory for the zoom position will not operate when a projection lens without the zoom function is used.
f The numeric value information of the zoom position is displayed only in following cases.
g When the standard DC motor unit installed in the Zoom Lens (Model No.: ET-D75LE6, ET-D75LE8, ET-D75LE10, ET-D75LE20,
ET-D75LE30, ET-D75LE40, etc.) is replaced with the stepping motor unit using the Stepping Motor Kit (Model No.: ET-D75MKS10)
g When the Zoom Lens with the stepping motor (Model No.: ET-D3LEW60, ET-D3LET80, ET-D3LEW10, ET-D3LES20, etc.) is attached
f The saved lens memory is loaded in order every time the <FUNCTION> button is pressed when [LENS MEMORY LOAD] is assigned to the
<FUNCTION> button.
Deleting a lens memory
Press as to select [LENS].
1)
2)
Press the <ENTER> button.
f The [LENS] screen is displayed.
Press as to select [LENS MEMORY].
3)
4)
Press the <ENTER> button.
f The [LENS MEMORY] screen is displayed.
Press as to select [LENS MEMORY EDIT].
5)
Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 169
Advertisement
Table of Contents
