Table of Contents
Advertisement
12) Press the <ENTER> button.
f The confirmation screen is displayed.
13) Press qw to select [OK], and press the <ENTER> button.
Note
f The settings in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] are displayed in [EDID STATUS].
f The resolution and vertical scanning frequency settings may also be required on your computer or video device.
f The computer, video device, or projector in use may require the power to be turned off and on again after configuring settings.
f A signal may not be output with the resolution and vertical scanning frequency that have been set, depending on your computer or video
device.
When the optional Interface Board for DVI-D 2 input (Model No.: ET-MDNDV10) is installed
Setting [DVI-D LINK] in [SLOT IN] (DVI-D input)
This can be set when the optional Interface Board for DVI-D 2 input (Model No.: ET-MDNDV10) is installed in both
of the slots.
Press as to select [SLOT IN].
1)
2)
Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
Press as to select [DVI-D LINK], and press the <ENTER> button.
3)
f The [DVI-D LINK] screen is displayed.
Press as to select the setting.
4)
[AUTO]
[SINGLE]
[QUAD]
5)
Press the <ENTER> button.
Note
f [DVI-D LINK] is fixed to [SINGLE] in the following cases.
g When the [DISPLAY OPTION] menu → [SIMUL INPUT SETTING] is set to [AUTO(x2-speed)]
f When the [PROJECTOR SETUP] menu → [NO SIGNAL SETTING] → [BACKUP INPUT SETTING] → [BACKUP INPUT MODE] is set as
the combination to use the DVI-D input, the [DVI-D LINK] setting cannot be changed.
f The content set is displayed in [DVI-D LINK SETTINGS].
r Structure of the projected image
The single link is a setting to display one image with one input signal. The quad link is a setting to display one
image with four input signals.
Setting [SIGNAL LEVEL] in [SLOT IN] (DVI-D input)
Press as to select [SLOT IN].
1)
Chapter 4 Settings — [DISPLAY OPTION] menu
Automatically selects the single link or the quad link.
Selects the quad link when the signal in the same format (such as resolution and timing) is input in
the four inputs of DVI-D1, DVI-D2, DVI-D3, and DVI-D4.
Sets the DVI-D1 input, the DVI-D2 input, the DVI-D3 input, and the DVI-D4 input to single link.
(Factory default setting)
Sets the DVI-D1 input, the DVI-D2 input, the DVI-D3 input, and the DVI-D4 input to quad link.
Single link
DVI-D1
DVI-D2
DVI-D3
DVI-D4
Quad link
ENGLISH - 145
Advertisement
Table of Contents
