Connecting Right Transport Harness - MacDon R113 Installation Instructions Manual

8. Route harness (A) to light (B) on header as shown.
9. Retrieve p-clips(MD #135235), plastic clamps (MD #184301)
, and cable ties (MD #21763) from the shipping bag.
10. Remove bolts (C) on header at locations shown.
11. Secure harness (A) with p-clips (MD #135235), existing bolts
(C), and plastic clamp (D) (MD #184301) into existing holes.
NOTE:
R113: Harness for rotary disc pull-type is secured with one
plastic clamp (D) (MD #184301).
NOTE:
R116: Harness for rotary disc pull-type is secured with two
plastic clamps (MD #184301).
12. Secure harness (A) to the light bracket with two
cable ties (E) (MD #21763).
13. Push any excess harness into the carrier frame.
14. Connect plug P401 and P404 into light (B).

3.4.3 Connecting Right Transport Harness

1. Route transport harness (A) from opening (B) into light
bracket (C) and plug it into the light connectors.
2. Secure harness (A) to the light bracket with two cable
ties (D) (MD #21763).
3. Push any excess harness into the carrier frame.
214633
INSTALLATION INSTRUCTIONS
A
Figure 3.57: Harness Routing – R113 Shown, R116
Similar
C
Figure 3.58: Transport Light
35
C
E
B
D C
A
D
B
Revision C