MacDon R113 Installation Instructions Manual page 81

6. Check distance (C) between tractor primary power take-off
(PTO) shaft (A) and rotary disc pull-type hitch gearbox
shaft (B) without the front half of the driveline attached.
7. Ensure that distance measurement (C) does NOT exceed
the dimensions listed in Table
Table 6.1 Distance between Hitch Gearbox and Tractor PTO
Driveline Shaft Size
34 mm (1 3/8 in.)
43 mm (1 3/4 in.)
8. Position primary driveline (A) onto the tractor's PTO shaft,
making sure that the driveline is approximately level.
9. Pull back the collar on driveline (A) and push the driveline
until it locks. Release the collar.
9. If distance (C) is greater than the values shown, a longer driveline is required. Refer to the rotary disc pull-type
operator's manual, options and attachments section for ordering information.
214633
REFERENCE
6.1, page 69.
Distance (C) 9
650 mm (25 9/16 in.)
750 mm (29 1/2 in.)
69
C
A
B
Figure 6.20: Allowable Driveline Length – Model Year
2019 and Prior
C
A
B
Figure 6.21: Allowable Driveline Length – Model Year
2020 and Later
Figure 6.22: Driveline Attached to Tractor PTO
A
Revision C