MacDon R113 Installation Instructions Manual page 36

3. Secure cam assembly (A) onto hitch swing cylinder plate (B)
with bolts and nuts (C). Torque nuts (C) to 55–60 Nm
(40–45 lbf·ft).
NOTE:
When installing cam assembly (A), check for hose twisting.
If required, loosen hose fitting to allow hose to untwist.
Torque fitting when complete.
4. Check travel of cam arm (A) by sliding it in and out of cam
assembly (B).
NOTE:
If the cam arm does NOT slide easily, loosen valve
mounting bolts (C) and position valve (B) at the top of the
mounting holes. Retighten valve mounting bolts (C).
5. Align hole in cam arm (A) with hole in clevis (B) on the rod
end of the cylinder.
214633
INSTALLATION INSTRUCTIONS
Figure 3.32: Alignment Control – Rear Right View
Figure 3.33: Alignment Control – Rear Right View
Figure 3.34: Alignment Control – Rear Right View
24
B
C
B
C
A
A
A
B
Revision C