MacDon R113 Installation Instructions Manual page 37

6. Ensure the end of cam arm (A) is parallel with clevis (B) on
the rod end of the cylinder. If adjustment is required, use a
bar to turn the clevis until the clevis is parallel with
cam arm (A).
NOTE:
The rod end of the cylinder will be attached to the
transport casting after the system is primed. For
instructions, refer to 3.7 Priming the Hitch Swing Cylinder,
page 42.
7. Retrieve completion valve assembly (A) and one M12 x 25
flanged hex head bolt (MD #136399) from the shipping bag.
8. Remove bolts (B) from the standoffs on the rear of the
carrier. Install valve assembly (A) behind support plate (C).
Secure it to the standoffs using the three M12 x 25 flanged
hex head bolts (B).
214633
INSTALLATION INSTRUCTIONS
Figure 3.35: Cam Arm Alignment
Figure 3.36: Control Valve
25
C
B
A
B
A
Revision C