MacDon R113 Installation Instructions Manual page 55

NOTE:
Ensure there is no contact with the rear link arm when the hitch swing cylinder extends.
2. With the cylinder disconnected from the rear arm link, using the tractor's hydraulics, extend and retract swing
cylinder (A) several times to purge any air in the cylinder.
Figure 3.72: Hydraulic System
3. Align the clevis pinholes in cylinder clevis (B), cam arm (C),
and rear link arm (A).
4. Install clevis pin (D) and secure with cotter pin (E) (not
shown).
214633
INSTALLATION INSTRUCTIONS
A
A
Figure 3.73: Rear Arm Link
43
C
D
E
B
Revision C