MacDon R113 Installation Instructions Manual page 60

3. Connect the hitch swing cylinder hoses (collars with #2) to
tractor's hydraulic circuit (A). For instructions, refer to
Connecting Hydraulics, page
4. Raise the rotary disc pull-type fully and close the lift
cylinder lock-out valve by turning handle (A) to the closed
position (90° to the hose). Repeat on the opposite side.
5. Swing the rotary disc pull-type completely to the left, then
completely to the right. Repeat three or four times to
charge the hitch swing circuit.
6. Swing the rotary disc pull-type so that it is centered behind
the tractor.
7. Close the hitch swing lock-out valve by turning handle (A)
to the closed position (90° angle to the hose).
8. Ensure tires are properly inflated.
9. Ensure the slow moving vehicle (SMV) sign, reflectors, and
lights are clean and visible at rear of rotary disc pull-type.
10. Refer to 5.2 Transporting with a Tractor, page 49
transport instructions.
214633
TRANSPORTING THE ROTARY DISC PULL-TYPE
3.6
41.
for
Figure 5.1: Hydraulic Connection
Figure 5.2: Cylinder Lock-Out Valve
A
Figure 5.3: Hitch Swing Lock-Out Valve Shown in
Closed Position
48
A
A
Revision C