Installing Left Transport Harness - MacDon R113 Installation Instructions Manual

8. Install light assembly (A) onto the header left end with two
M10 x 20 carriage bolts (B) (MD #136178) and lock nuts
(MD #50101) from the shipping bag. Ensure the amber
lamp faces the front of header and reflector faces
outboard.

3.4.2 Installing Left Transport Harness

1. Retrieve transport harness (A) (MD #281614) from the
shipping bag.
2. Route connectors P201 and P202 on the end of harness (A)
to cover support (D).
3. Using a draw tape or equivalent, route connectors P401
and P404 on the other end of the harness (A) through
opening (B) at front of carrier to opening (C) adjacent to
center-link.
4. Route the harness until the plugs reach the left light
assembly (E) on the header.
5. Locate plug P301 (D) on harness (E) (MD #281613)
disconnected from the lighting module.
6. Connect plug P201 (B) on harness (A) (MD #281614) into
the lower output receptacle on the lighting module.
7. Connect plug P301 (D) to receptacle P202 (C).
7. Part number is for reference only. Part is not included in the kit.
214633
INSTALLATION INSTRUCTIONS
Figure 3.54: Header Left Side Lighting
Figure 3.55: Harness Routing
7 . It was
Figure 3.56: Harness Connection
34
A
B
D
A
C
B
E
D
B
C
A
E
Revision C