Chapter 5: Transporting The Rotary Disc Pull-Type; Preparing Rotary Disc Pull-Type For Transport - MacDon R113 Installation Instructions Manual

Chapter 5: Transporting the Rotary Disc Pull-Type

You can transport the rotary disc pull-type using a tractor in either field mode or transport mode.
• To prepare a rotary disc pull-type for towing with a tractor in field mode without using the Road-Friendly Transport
option, refer to 5.1 Preparing Rotary Disc Pull-Type for Transport, page
• To prepare a rotary disc pull-type for towing with a tractor using the Road-Friendly Transport
Converting from Field to Transport Mode – With Road-Friendly Transport
CAUTION
• Obey all highway traffic regulations in your area when transporting on public roads. Use flashing amber lights unless
prohibited by law.
• Be aware of roadside obstructions, oncoming traffic, and bridges.
• Travel at safe speeds to ensure complete machine control and stability at all times. Do NOT exceed 32 km/h
(20 mph). Reduce speed for corners and slippery conditions.
• Use tractor lights and rotary disc pull-type flashing amber and red taillights when transporting on roads in order to
provide adequate warning to operators of other vehicles.
• Do NOT transport the rotary disc pull-type on a road or highway at night or in reduced visibility conditions such as
rain or fog.
• Ensure that hitch on transporting vehicle is capable of handling a 907 kg (2000 lb.) static vertical load.
• Do NOT tow with any highway-capable vehicle. Use only an agricultural tractor with a sufficient weight such that
the fully loaded implement weighs no more than 1.5 times the weight of the tractor.

5.1 Preparing Rotary Disc Pull-Type for Transport

Follow these instructions to prepare the rotary disc pull-type for transport without deploying the optional Road-Friendly
™
Transport system.
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.
WARNING
Do NOT tow unless the hitch swing cylinder is fully charged. If hitch swing cylinder is not fully charged, loss of control,
injury, or death could result.
1. Shut down the engine, and remove the key from the ignition.
2. Connect the rotary disc pull-type hitch to the tractor, and store the jack stand. For instructions, refer to
Rotary Disc Pull-Type to the Tractor, page
214633
61.
47
47.
™
option, refer to
™
, page 51.
™
5.4
6.1 Attaching
Revision C