Installing Transport Assembly - MacDon R113 Installation Instructions Manual

3.2.2 Installing Transport Assembly

1. Remove bolts (A), hardened washers, and nuts securing
slow moving vehicle (SMV) sign (B) to the carrier frame.
Remove the sign. Retain the sign for reinstallation. Discard
the two bolts, washers, and nuts.
2. Remove transport wheels (A) from the pallet.
3. Remove five M20 hex head bolts (B) (MD #136157),
washers (MD #112130), and nuts (MD #136122) in
transport assembly pin (C). Do NOT remove the pin.
4. Using a forklift, pick up the pallet holding transport
assembly (A) and align it with the rear of the rotary disc
pull-type.
5. Position the assembly close behind the frame and align
pin (B) in transport assembly with hole (C) in the carrier.
Use a soft hammer or equivalent to fully insert pin (B).
214633
INSTALLATION INSTRUCTIONS
Figure 3.8: SMV Sign Attached to Carrier Frame
B
Figure 3.9: Transport Packing
Figure 3.10: Road-Friendly Transport
16
B
C
B
A
A
A
C
™ ™
Revision C