MacDon R113 Installation Instructions Manual page 5

Section
2.2 Transport Assembly Parts List –
Small Parts Bag, page 8
2.3 Remote Control Parts List, page 10
3.1 Moving Hitch Swing Cylinder, page
13
• Step
1, page 13
3.1 Moving Hitch Swing Cylinder, page
13
• See the NOTE below Step
13
3.2.1 Installing Latch Assembly, page
14
• Step
4, page 14
• Step
5, page 14
• Step
6, page 14
3.2.1 Installing Latch Assembly, page
14
• Step
7, page 14
• Step
8, page 14
• Step
9, page 14
• Step
11, page 15
• Step
12, page 15
214633
• Added one electrical cap (MD #134742) for a total
quantity of one.
• Added one electrical harness (MD #281614) for a
total quantity of one.
Created a topic and parts list for the small parts bag
included with the transport assembly, and revised the
parts list as follows:
• Identified fitting MD #136149 as a separate part.
ECN 56030:
• Added footnote: Only used on a pull-type from model
year 2017 or prior.
ECN 57834:
• Added two screws (MD #136313) for a total quantity
of two.
• Added two nuts (MD #030855) for a total quantity
of two.
Added footnotes:
• MD #50101: Only four are used.
• MD #184657: Not used.
Added topic and parts list for the remote control and
harness.
Added step for model years 2018 and prior.
Revised the NOTE to read "rod end" (previously was
"clevis end"):
• The rod end of cylinder will be attached to the
6, page
transport casting when the system is primed.
Added steps and associated pictures to show new
electrical caps.
Revised steps and/or associated pictures to show new
latch assembly hydraulics.
Summary of Change
iii
Internal Use Only
ECN 56030
ECN 57834
Tech Pubs
ECN 56953
ECN 57017
Product Support
Product Support
ECN 57593
ECN 56030
Revision C