MacDon R113 Installation Instructions Manual page 64

3. While the light is illuminated, raise the rotary disc pull-
type fully by extending the field wheel cylinders.
4. Operate the hitch swing control lever to rotate the rotary
disc pull-type to the right until the cam bearing nut is
aligned with the green section of the transport alignment
gauge decal.
5. Move the transport switch to the upper position and
ensure that the light is NOT illuminated. The hitch swing
circuit is now deactivated and the transport circuit is active.
214633
TRANSPORTING THE ROTARY DISC PULL-TYPE
52
Figure 5.7: Raising Rotary Disc Pull-Type
Figure 5.8: Rotary Disc Pull-Type Rotation
Figure 5.9: Transport Switch
Revision C