Installing Transport Wheels - Factory-Installed Transport - MacDon R113 Assembly Instruction Manual
Rotary disc pull-type
Hide thumbs
Also See for R113:
- Operator's manual (294 pages) ,
- Unloading and assembly instructions (166 pages) ,
- Assembly instruction manual (136 pages)
Table of Contents
Advertisement
6.3 Installing Transport Wheels – Factory-Installed Transport
The pull-type rolls on the transport wheels when the transport is deployed into road mode. They are also used to convert
the pull-type between field and road mode.
1. Retrieve clevis pin (A) and cotter pin (B) from shipping bag
and install onto hitch bracket at side of hitch.
2. Remove bolt (B) holding axle assembly (A) in place.
3. Slide axle assembly (A) out of the support.
4. Install axle assembly (A) into the opposite side of the
support as shown.
5. Install bolt (B) and nut to secure it. Torque nut to 68 Nm
(50 lbf·ft).
6. Remove wheel bolts from hub (A).
215585
COMPLETING ROTARY DISC PULL-TYPE ASSEMBLY
113
Figure 6.8: Latch Pin
Figure 6.9: Axle Assembly Relocation
Figure 6.10: Axle Assembly Relocation
Revision A
Advertisement
Table of Contents
