Table of Contents
Advertisement
NOTE
• The doors cannot be locked or unlocked.
• The trunk lid cannot be opened.
• The panic alarm cannot be operated.
• The indicator light (5) is dim or does not
come on.
If you lose your F.A.S.T.-key, please contact
an authorized Mitsubishi Motors dealer for a
replacement.
If you wish to obtain an additional F.A.S.T.-
key, please contact an authorized Mitsubishi
Motors dealer. A maximum of four F.A.S.T.-
key can be programmed for your vehicle.
To use the new remote control transmitters, it
is necessary to register the key with both the
electronic immobilizer and keyless entry sys-
tem.
Also refer to "Electronic immobilizer (Anti-
theft starting system): Customer F.A.S.T.-
key programming" on page 5-27.
General information
Your F.A.S.T.-key operates on a radio fre-
quency subject to Federal Communications
Commission (FCC) Rules (For vehicles sold
in U.S.A.) and Industry Canada Rules (For
vehicles sold in Canada). This device com-
plies with Part 15 of FCC Rules and Industry
Canada licence-exempt RSS standard(s).
Operation is subject to the following two con-
ditions.
Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)
This device may not cause harmful inter-
ference.
This device must accept any interference
received, including interference that may
cause undesired operation.
CAUTION
Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user's authority to oper-
ate the equipment.
Procedure for replacing the
remote control transmitter battery
1. Before replacing the battery, remove static
electricity from your body by touching a
metal grounded object.
N00561601074
2. With the Mitsubishi mark facing you,
insert the cloth-covered tip of a flat blade
screwdriver into the notch in the remote
control transmitter case and use it to open
the case.
N00561700094
NOTE
Be sure to perform the procedure with the
Mitsubishi mark facing you. If the Mitsubi-
shi mark is not facing you when you open the
remote control transmitter case, the transmit-
ter may come out.
3. Remove the old battery.
Features and controls
5
5-33
Advertisement
Table of Contents
