Table of Contents
Advertisement
NOTE
The control mode can be changed while the
vehicle is moving.
The selected control mode is stored in mem-
ory even if the engine is stopped.
However, if a battery terminal is discon-
nected, the control mode stored in memory
will be erased and the control mode will be
set to the "TARMAC" mode.
S-AWC control mode display
Example: "TARMAC" mode is selected.
The currently selected control mode is dis-
played on the multi-information display.
In addition, when the control mode is
changed, the selected mode appears on the
interrupt display screen of the information
screen in the multi-information display.
The control mode display will appear on the
information screen for a few seconds, and
then the original screen will return.
CAUTION
The S-AWC control mode display may flash
under aggressive driving conditions.
At this time, S-AWC control is temporarily
suspended in order to protect the S-AWC
device, but this will not affect normal driv-
ing.
After the vehicle is driven for a while, if the
S-AWC control mode display remains on,
the S-AWC control will start operating again.
S-AWC operation display
The S-AWC operation status can be displayed
on the information screen in the multi-infor-
mation display.
To display the status, press the multi-informa-
tion meter switch to change the information
screen.
Refer to "Information screen (when the igni-
tion switch is "ON")" on page 5-97.
S-AWC (Super-All Wheel Control)
Display example
The S-AWC operation status is displayed.
AYC operation display
The amount of the yaw moment added by
AYC is displayed as a bar graph.
A, D- Clockwise yaw moment about the
vehicle's center of gravity
B, C- Counterclockwise yaw moment
about the vehicle's center of gravity
ACD operation display
N00542500048
The strength of the differential limiting
action (center differential) of the ACD is
displayed in section E of the meter as a bar
graph.
Features and controls
5
5-73
Advertisement
Table of Contents
