Table of Contents
Advertisement
4. Release in sequence the LOCK and
UNLOCK buttons within 10 seconds of
pressing the LOCK button in step 3.
Using the panic alarm
If you are near your vehicle and feel threat-
ened, you may activate the alarm to call atten-
tion as follows:
1. Press the PANIC button (4) for more than
1 second.
2. The headlights will blink on and off and
the horn will sound intermittently for
about 3 minutes.
3. To turn off the alarm, press any button on
the remote control transmitter.
Replacement remote control
transmitters
Only
remote
control
transmitters
grammed with the vehicle's electronics can
lock or unlock all doors.
If you lose the remote control transmitter, you
can order a remote control transmitter from
an authorized Mitsubishi Motors dealer by
referring to the key number.
To prevent vehicle theft, the ID codes for all
the remote control transmitters except the one
for the lost key must be programmed again.
Take your vehicle and all the remaining
remote control transmitters to an authorized
Mitsubishi Motors dealer to have your ID
N00543700047
codes programmed again.
Additional remote control
transmitters
To add a remote control transmitter, you must
already have one registered remote control
transmitter.
Registering the ID code can be done by your-
self or by your authorized Mitsubishi Motors
dealer. For you to register the ID code your-
self, follow the "Customer remote control
transmitter programming" procedure below.
If you choose to have an authorized Mitsubi-
shi Motors dealer register the ID code, take
N00543800022
your vehicle and all remaining keys to an
pro-
authorized Mitsubishi Motors dealer.
NOTE
You are provided with two remote control
transmitters, but you may register up to eight
remote control transmitters.
Keyless entry system (if so equipped)
Customer remote control trans-
mitter programming
You can program new remote control trans-
mitters to the system if you have one valid
(already registered) remote control transmit-
ter by doing the following:
1. Have available all (current and new)
remote control transmitters you wish to
register.
N00543900023
2. With a valid (already registered) remote
control transmitter, press the UNLOCK
button (2) for 4 to 10 seconds. Then press
and hold the LOCK button (1).
3. Within 10 seconds of pressing the LOCK
button, release the LOCK and UNLOCK
buttons in sequence. At this time, ID
codes for all remote control transmitters
except for the transmitter used in steps 2
and 3 are erased and the answerback func-
tion (door is locked and unlocked)
informs you that the registration mode has
been activated.
4. Within 60 seconds after step 3, complete
the following ID code registration opera-
tion using the next remote control trans-
mitter you wish to register within 4
seconds.
i. Press both the LOCK and UNLOCK
buttons for 2 seconds.
Features and controls
N00544001132
5
5-9
Advertisement
Table of Contents
