Table of Contents
Advertisement
Volume up button
Press this button to increase the volume.
Volume down button
Press this button to decrease the volume.
SPEECH button
Press this button to change to voice recog-
nition mode.
While the system is in voice recognition
mode, "Listening" will appear on the
audio display.
NOTE
On a vehicle equipped with a Mitsubishi
Multi-Communication System, pressing the
SPEECH button will beep and activated the
voice recognition mode of Mitsubishi Multi-
Communication System. When you use the
voice recognition of the Bluetooth
interface, press the PICK-UP button.
If you press the button briefly while in
voice recognition mode, it will interrupt
prompting and allow voice command
input.
Pressing the button longer will deactivate
the voice recognition mode.
Pressing this button briefly during a call
will enable voice recognition and allow
voice command input.
PICK-UP button
Press this button when an incoming call is
received to answer the telephone.
NOTE
On a vehicle equipped with a Mitsubishi
Multi-Communication System, pressing the
PICK-UP button except when an incoming
call is received to answer the telephone will
activate the voice recognition of the Blue-
®
tooth
2.0 interface.
When another call is received during a
call, press this button to put the first caller
on hold and talk to the new caller.
• In such circumstances, you can press the
button briefly to switch between callers.
You will switch to the first caller and the
®
other caller will be put on hold.
2.0
• To establish a three-way call in such situ-
ations, press the SPEECH button to enter
voice recognition mode and then say
"Join calls."
Bluetooth® 2.0 interface
HANG-UP button
Press this button when an incoming call is
received to refuse the call.
Press this button during a call to end the
current call.
When another call is on hold, you will
switch to that call.
If this button is pressed in the voice recog-
nition mode, the voice recognition mode
will be deactivated.
NOTE
When you press the SPEECH button to enter
voice recognition mode with a cellular phone
paired to the system, current information on
the cellular phone, such as "remaining bat-
tery life," "signal strength" or "roaming,"
will be displayed on the audio display.*
*: Some cellular phones will not send this
®
information to the Bluetooth
2.0 interface.
Call waiting and three-way calls can be used
®
by the Bluetooth
2.0 interface, only if it is
possible to use those services with your cel-
lular phone.
Microphone
Your voice will be recognized by a micro-
phone in the overhead console, allowing you
Features and controls
5
N00575800025
5-139
Advertisement
Table of Contents
