Table of Contents
Advertisement
3. Pull the seat belt out slowly while holding
the latch plate. Push the latch plate into
the buckle until you hear a "click". Pull
up on the belt to be sure the latch plate is
locked securely in the buckle.
NOTE
If the seat belt locks up and cannot be pulled
out, pull it once with force and let it retract
all the way.
Then, pull the belt out slowly once again.
4. The lap part of the belt must always be
worn low and snug across the hips. Pull
up on the shoulder portion of the belt to
take up any slack in the lap belt.
NOTE
With the exception of the seat belt for the
driver, the seat belts in all other seating posi-
tions are equipped with an Automatic Lock-
ing Retractor (ALR) function. If you pull the
seat belt fully out of the retractor, the retrac-
tor will switch to its ALR child restraint
installation function (see page 4-17).
When the ALR function has been activated,
the seat belt will only retract. If this happens,
let the belt fully retract, then pull the seat
belt back out, repeating steps 1 through 4.
WARNING
Be sure the lap belt portion fits snugly and
is worn as low as possible across the hips,
not around the waist. Failure to follow this
instruction will increase the risk of serious
injury or death in the event of an accident.
Be sure the seat belt webbing is not
twisted when worn. Twisted webbing may
adversely affect seat belt performance.
5. To release the belt, press the button on the
buckle and allow the belt to retract.
If the belt does not retract smoothly, pull it
out and check for kinks or twists in the
webbing. Then make sure it remains
untwisted as it retracts.
Driver's seat belt
reminder/warning light and
display
Warning light
Seat and restraint systems
Seat belts
4
N00418400326
4-9
Advertisement
Table of Contents
