Table of Contents
Advertisement
General maintenance
there are other parts which do not usually
need regular maintenance.
But, if any of these parts stops working prop-
erly, your vehicle performance could suffer.
Have these items checked if you notice a
problem with them.
See your authorized Mitsubishi Motors dealer
for assistance, if you have any questions.
Disc brake pads
Good brakes are essential to safe driving.
Check the brake pads for wear. For good
9
braking performance, replace the brake pads
with the same type pads as the originals.
Brake hoses
Brake hoses and tubing should be checked
for:
Severe surface cracking, scuffing or worn
spots. If the fabric casing of the hose is
showing through any cracks or worn spots
in the rubber hose cover, the hose should
be replaced. The brakes can fail if the
hose wears through.
Improper installation may cause twisting,
or wheel, tire or chassis interference.
9-22
Vehicle care and maintenance
Ball joint, steering linkage seals
and drive shaft boots
Check the following parts for damage and
grease leaks:
Ball joint boots of the front suspension
and steering linkage
Bellows on both ends of the drive shaft
Exhaust system
N00941600062
WARNING
Carbon monoxide gas from your vehicle's
exhaust is poisonous. Breathing these
fumes can cause unconsciousness or death.
N00941700047
The best way to keep carbon monoxide gas
from entering inside your vehicle is to have
the engine exhaust system properly serviced.
Have a competent mechanic inspect the com-
plete exhaust system and nearby body areas
for broken, damaged, deteriorated, or mispo-
sitioned parts if you notice any of the follow-
ing:
A change in the sound of the exhaust sys-
tem
The smell of exhaust fumes inside the
vehicle
The underside or rear of the vehicle is
damaged
Also check the exhaust system each time the
N00941800077
vehicle is raised for lubrication, oil changes,
or required service. Any open seams or loose
connections could let dangerous exhaust
fumes seep into the luggage compartment and
passenger compartments.
Check for any of the following
conditions:
N00942200108
Check for holes or exhaust gas leaks
caused by corrosion or damage.
Check the joints and connections for
looseness or exhaust gas leaks.
Check the rubber hangers and brackets for
damage.
Hood lock release mechanism
and safety catch
The hood lock release mechanism and hood
safety catch should be checked, cleaned, and
oiled when needed for easy movement and to
stop rust and wear. Use Multipurpose Grease
NLGI Grade 2 sparingly for all sliding parts
of the hood latch and release lever. Work the
grease into the hood lock mechanism until all
the movable surfaces are covered.
N00942500042
Advertisement
Table of Contents
