Mitsubishi MOTORS LANCER EVOLUTION 2014 Manual page 35

Seat belts
Warning display
4
A tone and warning light are used to remind
the driver to fasten the seat belt.
If the ignition switch is turned to the "ON"
position without the driver's seat belt being
fastened, a warning light will come on and a
tone will sound for approximately 6 seconds
to remind you to fasten your seat belt.
If you then drive with the seat belt unfastened
for longer than a minute from when the igni-
tion switch was turned to the "ON" position,
the warning light will come on and blink
repeatedly and the tone will sound intermit-
tently.
The warning light and the tone will stop after
approximately 90 seconds.
If you then repeatedly stop and start your
vehicle with the seat belt unfastened, the
warning light/display and tone will remind
you to fasten your seat belt every time the
vehicle starts moving. You will also be
reminded to fasten your seat belt in this way
when you remove your seat belt while driv-
ing. The warning light and the tone go off
when the seat belt is fastened.
4-10 Seat and restraint systems
WARNING
 In order to reduce the risk of serious
injury or death in an accident, always
wear your own seat belt. Do not allow any-
one to ride in your vehicle unless he or she
is also seated and wearing a seat belt.
Children should additionally be restrained
in a secure child restraint system.
NOTE
 At the same time, "FASTEN SEAT BELT"
will be displayed on the information screen
in the multi-information display.
Front passenger seat belt warn-
ing light
The front passenger seat belt warning light is
located in the instrument panel.
When the ignition switch is turned to the
"ON" position, this indicator normally comes
on and goes off a few seconds later.
The light comes on when a person sits on the
front passenger seat but does not fasten the
seat belt. It goes off when the seat belt is sub-
sequently fastened.
WARNING
 Do not install any accessory or sticker that
makes the light difficult to see.
Adjustable seat belt shoulder
anchor (front seats)
To move the anchor down, press the lock
knob (A) and slide the anchor down to the
N00418300178
desired position.
To move the anchor up, slide the anchor up to
the desired position.
N00406300269