Mitsubishi MOTORS LANCER EVOLUTION 2014 Manual page 69

Keyless entry system (if so equipped)
Answerback function
Setting of the horn and turn signal lights of
the keyless entry system answerback function
can be changed as required. This is done with
the key removed from the ignition switch.
5
NOTE
 The answerback function does not operate
when the key is in the ignition switch or any
doors is opened.
Horn deactivation/reactivation
The horn answerback function can be set to
the following three conditions.
Each time the horn answerback function is
set, a chime will sound to tell you the condi-
tion of the answerback function.
Number of
Condition
chimes
One chime The horn will not sound.
Two chimes The horn will sound.
The horn will sound if the
Four chimes LOCK button (1) is pressed
twice quickly.
1. Remove the key from the ignition switch.
5-8 Features and controls
2. Open the driver's door and turn the com-
bination headlights and dimmer switch to
N00543501097
the "OFF" position.
3. Press the LOCK button (1) for 4 to 10 sec-
onds and press the UNLOCK button (2)
during this time.
4. Release in sequence the UNLOCK and
LOCK buttons within 10 seconds of
pressing the UNLOCK button in step 3.
Changing the setting of the turn
signal lights answerback function
The turn signal lights answerback function
can be set to the following seven conditions.
Each time the turn signal lights answerback
function is set, a chime will sound to tell you
the condition of the answerback function.
Number of
chimes
To lock
One chime One flash
Two chimes One flash
Three chimes No flash
Four chimes Two flashes One flash
Five chimes No flash
Six chimes Two flashes No flash
Seven chimes No flash
1. Remove the key from the ignition switch.
2. Open the driver's door and turn the com-
bination headlights and dimmer switch to
the "OFF" position.
3. Press the UNLOCK button (2) for 4 to 10
seconds and press the LOCK button (1)
during this time.
4. Release in sequence the UNLOCK and
LOCK buttons within 10 seconds of
pressing the LOCK button in step 3.
Setting of door unlock function
The door unlock function can be set to the
following two conditions.
Each time the door unlock function is set, a
chime will sound to tell you the condition of
the door unlock function.
Number of
Condition
chimes
To unlock
One chime
Two flashes
Two chimes Driver's door unlock only
No flash
Two flashes
1. Remove the key from the ignition switch.
2. Open the driver's door and turn the com-
bination headlights and dimmer switch to
One flash
the "OFF" position.
3. Press the LOCK button (1) for 4 to 10 sec-
No flash
onds and press the UNLOCK button (2)
during this time.
N00543601131
Condition
All doors unlock