Table of Contents
Advertisement
Electronic immobilizer (Anti-theft starting system)
Customer key programming
(Except for vehicles sold in
Canada)
You can program new keys to the system if
you have two valid (already registered) keys
5
and blank (not registered) immobilizer key
(specially cut for your vehicle at your Mit-
subishi Motors dealer) by doing the follow-
ing:
1. Insert the first valid key into the ignition
switch and turn the key to the "ON" posi-
tion for 5 seconds.
2. Turn the key to the "LOCK" position and
remove the first key.
3. Within 30 seconds of turning the first key
to the "LOCK" position, insert the second
valid key into the ignition and turn it to
the "ON" position. About 10 seconds
later, the immobilizer display will start to
blink.
5-6
Features and controls
4. When the immobilizer display starts
blinking, turn the second valid key to the
"LOCK" position and remove it. Within
30 seconds after doing so, insert a blank
immobilizer key into the ignition switch
N00562200070
and turn it to the "ON" position. Perform
this operation no more than 30 seconds
after the immobilizer display starts blink-
ing. When registration of the ID code is
complete, the immobilizer display will
come on for 3 seconds then go off. If an
error occurs, the immobilizer display will
go off during the procedure.
5. If you wish to register another key, per-
form the process again from step 1.
NOTE
Perform the operation when the interrupt dis-
play screen is not showing. The interrupt dis-
play screen may prevent you from seeing the
immobilizer display.
It is not possible to register a key if:
• the immobilizer display goes off during the
procedure
• the immobilizer display does not come on
within 30 seconds after turning the ignition
switch to the "ON" position with a blank
immobilizer key
NOTE
The procedure will be terminated automati-
cally if:
• a period of 30 seconds or longer elapses
from the moment when the first key is
turned to the "LOCK" position to the
moment when the second key is turned to
the "ON" position
• a period of 30 seconds or longer elapses
from the moment when the second key is
turned to the "LOCK" position to the
moment when the blank immobilizer key is
turned to the "ON" position
To use the new remote control transmitters, it
is necessary to register the key with both the
electronic immobilizer and keyless entry sys-
tem.
Also refer to "Keyless entry system: Cus-
tomer remote control transmitter program-
ming" on page 5-9.
General information
Your electronic immobilizer operates on a
radio frequency subject to Federal Communi-
cations Commission (FCC) Rules (For vehi-
cles sold in U.S.A.) and Industry Canada
Rules (For vehicles sold in Canada). This
device complies with Part 15 of FCC Rules
and Industry Canada licence-exempt RSS
standard(s).
N00562301108
Advertisement
Table of Contents
