Table of Contents
Advertisement
Push the switch again and the air condition-
ing compressor will stop and the indicator
light (A) goes off.
CAUTION
Using the air conditioning slightly increases
the engine idle speed. Therefore, make sure
your foot is firmly on the brake pedal when
shifting the transaxle into drive.
NOTE
If a problem is detected in the air condition-
ing compressor, the air conditioning indica-
tor
light
(A)
blinks.
Press
conditioning switch once to turn it off, then
once more to turn it back on. If the air condi-
tioning indicator light does not blink there is
no problem. If it does blink, have it checked
at an authorized Mitsubishi Motors dealer or
a repair facility of your choice.
NOTE
Sometimes, for example after using a high-
pressure car wash, the condenser can get wet,
and the air conditioning indicator light (A)
blinks temporarily. Wait for a while, press
the air conditioning switch once to turn the
system off, then once more to turn it back on.
Once the water evaporates, the blinking will
stop.
Personalizing the air conditioning
switch (Changing the function set-
ting)
You can change the following functions to
match your preference.
Enable automatic air conditioning control:
When the mode selection dial or blower
speed selection dial has been set to the
"AUTO" position or when the tempera-
ture control dial has been set to the mini-
mum temperature, the air conditioning
switch is automatically controlled.
the
air
Disable automatic air conditioning con-
trol:
The air conditioning switch is not auto-
matically controlled, unless the air condi-
tioning switch is used.
Automatic air conditioning with Fahrenheit scale (if so equipped)
Changing the settings:
Press the air conditioning switch for about
10 seconds or longer.
When the setting has changed, the system
will beep and the indicator light will flash.
• When the setting has changed from
enabled to disabled,
the system will beep three times and the
indicator will flash three times.
• When the setting has changed from dis-
abled to enabled,
the system will beep two times and the
indicator light will flash three times.
N00759800032
The factory setting is "Enable automatic air
conditioning control".
While the mode selection dial is set between
"
ing will run automatically, even if the system
is set to "Disable automatic air conditioning
control", in order to prevent windows from
fogging up.
NOTE
" and "
" position, the air condition-
Comfort controls
7
7-7
Advertisement
Table of Contents
