Table of Contents
Advertisement
When the ignition switch is turned to the
"ON" position from the "ACC" or
"LOCK" position, the mode setting
changes automatically from manual to
auto.
Switching to auto occurs automatically. If
switching to manual mode is done, how-
ever, the data from the last reset is dis-
played.
Auto reset mode
When the average fuel consumption is
being displayed, if you hold down the
multi-information meter switch, these cal-
culations will be reset to zero.
When the ignition switch has been set to
the "ACC" or "LOCK" position for about
4 hours or more, the average fuel con-
sumption display will automatically reset.
NOTE
The average speed display and the average
fuel consumption display can be reset sepa-
rately in both auto reset mode and manual
reset mode.
"---" is displayed when the average fuel con-
sumption cannot be measured.
The initial (default) setting is "Auto reset
mode".
NOTE
Average fuel consumption may vary depend
on the driving conditions (road conditions,
how you drive, etc.) The actual fuel con-
sumption may differ from the fuel consump-
tion displayed, so treat the fuel consumption
displayed as just a rough guideline.
The average fuel consumption display mem-
ories for auto reset mode and manual reset
mode are erased if the battery is discon-
nected.
The display setting can be changed to the
preferred units {mpg (US), mpg (UK),
L/100km or km/L}.
Refer to "Changing the function settings
(With ignition switch in the "ON" position)"
on page 5-103.
Momentary fuel consumption dis-
play
While driving, the momentary fuel consump-
tion is shown with a bar graph.
When the momentary fuel consumption sur-
passes the average fuel consumption, the
momentary fuel consumption is displayed
with a green bar graph.
Be conscious of maintaining the momentary
fuel consumption above the average fuel con-
sumption, it can help you drive with the better
fuel consumption.
Multi-information display
NOTE
When the momentary fuel consumption can-
not be measured, a bar graph is not shown.
The display setting can be changed to the
preferred units {mpg (US), mpg (UK),
L/100km or km/L}.
Refer to "Changing the function settings
(With ignition switch in the "ON" position)"
on page 5-103.
It is possible to cancel the green bar graph.
Refer to "Changing the function settings
(With ignition switch in the "ON" position)"
on page 5-103.
S-AWC operation display
The S-AWC operation status is displayed.
For further details, refer to "S-AWC opera-
tion display" on page 5-73.
WARNING
Always concentrate on your driving first.
Keep your eyes and mind on the road. Dis-
tractions while driving can lead to an acci-
dent.
Function setting screen
The "Display language", "Temperature unit",
"Fuel consumption unit", and "Average fuel
Features and controls
5
5-99
Advertisement
Table of Contents
