Table of Contents
Advertisement
Keyless entry system (if so equipped)
ii. Release both the LOCK and UNLOCK
buttons for 1 second.
iii. Press the UNLOCK button. The
answerback function informs you that
the ID code registration of the transmit-
ter is completed.
5. To register the ID codes of additional
remote control transmitters, repeat step 4
5
within 60 seconds after step 4.
6. If no ID code of a remote control trans-
mitter is registered within 60 seconds
after step 4, the registration mode is can-
celed and the normal mode returns.
NOTE
For verification purposes, try to lock and
unlock the doors after the registration is
completed.
The indicator light (5) comes on each time a
button is pressed.
The keyless entry system does not work if
the key is in the ignition switch.
The remote control transmitter can be used
from about 40 feet (12 m) away. However,
this distance may change if your vehicle is
near a TV transmitting tower, a power sta-
tion, or a radio station.
If the UNLOCK button (2) is pressed when
all doors are locked and no doors are opened
within about 30 seconds, the doors will auto-
matically re-lock.
5-10
Features and controls
NOTE
If the following conditions are observed after
pressing the buttons on the remote control
transmitter, the battery in the remote control
transmitter may need to be replaced.
• The doors cannot be locked or unlocked.
• The trunk lid cannot be opened.
• The panic alarm cannot be operated.
• The indicator light (5) is dim or does not
come on.
If you lose your remote control transmitter,
please contact an authorized Mitsubishi
Motors dealer for a replacement.
If you wish to obtain an additional remote
control transmitter, please contact an autho-
rized Mitsubishi Motors dealer. A maximum
of eight remote control transmitters can be
programmed for your vehicle.
To use the new remote control transmitters, it
is necessary to register the key with both the
electronic immobilizer and keyless entry sys-
tem.
Also refer to "Electronic immobilizer (Anti-
theft starting system): Customer key pro-
gramming" on page 5-6.
General information
Your keyless entry system operates on a radio
frequency subject to Federal Communica-
tions Commission (FCC) Rules (For vehicles
sold in U.S.A.) and Industry Canada Rules
(For vehicles sold in Canada). This device
complies with Part 15 of FCC Rules and
Industry Canada licence-exempt RSS stan-
dard(s).
Operation is subject to the following two con-
ditions.
This device may not cause harmful inter-
ference.
This device must accept any interference
received, including interference that may
cause undesired operation.
CAUTION
Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user's authority to oper-
ate the equipment.
Procedure for replacing the
remote control transmitter bat-
tery
1. Before replacing the battery, remove static
electricity from your body by touching a
metal grounded object.
N00546101111
N00544100107
Advertisement
Table of Contents
