Table of Contents
Advertisement
3. Insert the emergency key into the ignition
switch, and slowly push and turn.
NOTE
When the ignition switch cannot be turned
from the "LOCK" position to the "ACC"
position, turn the ignition switch while turn-
ing the steering wheel in both directions.
Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)
To turn from "ACC" to "LOCK"
1. [For vehicles with manual transaxle]
Push the emergency key in at the "ACC"
position and keep it depressed until it is
turned to the "LOCK" position, and
remove.
[For vehicles with Twin Clutch SST
(sportronic shift transmission)]
First, set the gearshift lever to the "P"
(PARK) position, and then slowly turn the
ignition switch to the "LOCK" position
while pressing it.
NOTE
For vehicles with Twin Clutch SST, the
emergency key cannot be removed unless the
gearshift lever is set to the "P" (PARK) posi-
tion.
2. Install the cover of the ignition switch.
3. Reinsert the emergency key into the
F.A.S.T.-key.
NOTE
Always install the cover of the ignition
switch when not using the emergency key.
Not doing so could cause damage if foreign
material such as dust gets into the keyhole of
the ignition switch.
CAUTION
Do not turn the ignition switch to the LOCK
position while the vehicle is moving. This
will cause the steering wheel to lock, making
it impossible to operate the vehicle.
If the engine is stopped while driving, the
power brake booster will stop functioning
and greater effort for braking will be
required. Also, the power steering system
will not function and it will require greater
effort to manually steer the vehicle.
Do not leave the ignition switch in the "ON"
or "ACC" position for a long time when the
engine is not running. The battery will run
down.
Do not turn the ignition switch to the
"START" position when the engine is run-
ning. It will damage the starter motor.
Features and controls
5
5-23
Advertisement
Table of Contents
