Change The Scanner's Bluetooth Pin Code; Minimize Bluetooth/Ism Band Network Activity; Auto Reconnect Mode - Honeywell Voyager XP 1470g Series User Manual

Change the Scanner's Bluetooth PIN Code

Some devices require a PIN code as part of the Bluetooth security features. Your
scanner's default PIN is 1234, which you may need to enter the first time you con-
nect to your PDA or PC. The PIN code must be between 1 and 16 characters. To
change the PIN, scan the bar code below and then scan the appropriate numeric
bar codes from the

Minimize Bluetooth/ISM Band Network Activity

The settings described below can help you customize the relinking behavior of the
cordless area-imaging system to obtain the best compromise between conve-
nience and low interference.
Note: ISM band refers to the 2.4 to 2.48 GHz frequency band used by wireless networks,
cordless phones, and Bluetooth.

Auto Reconnect Mode

Auto Reconnect controls whether or not the scanner automatically begins the
relink process when a loss of connection is detected. When the Auto Reconnect On
bar code is scanned, the scanner begins the relink process immediately, without
user intervention. Default = Auto Reconnect On.
Note: If you are connecting to a Bluetooth Interface Module, set Auto Reconnect to Off.
The table below shows the results of the Auto Reconnect On and Off settings:
Event
Scanner out of range
Voyager 1470/1472 User Guide
Programming
* Auto Reconnect On
Auto Reconnect On
Relink occurs automatically. If maximum
number of link attempts is unsuccessful,
then the scanner must be relinked by
either pulling the trigger, placing the
scanner in the base, or scanning the
Access Point linking bar code (see
Maximum Link
Chart. Scan Save to save your selection.
Bluetooth PIN
Attempts).
Auto Reconnect Off
Auto Reconnect Off
The scanner is relinked by pulling the
trigger, or scanning the Access Point
linking bar code.
67