Table of Contents
Advertisement
Configuring RSVP-TE
Configuring an RSVP-TE LSP
To add an RSVP-TE LSP, use the following command:
config mpls rsvp-te add lsp <lsp_name> path <path_name> {<profile_name>}
{primary | secondary}
Both the
and
must be specified. The
parameter is
<lsp_name>
<path_name>
<lsp_name>
a character string that is to be used to identify the LSP within the switch. The
string must begin with an alphabetic character and can contain up to 31
<lsp_name>
additional alphanumeric characters. The
is optional. If omitted, the
<profile_name>
default profile is applied to the LSP. If no explicitly specified, the
defaults
<path_name>
to the primary path. The LSP is immediately signaled as soon as it is configured. The
maximum number of configurable LSPs is 1024.
To delete an RSVP-TE LSP, use the following command:
config mpls rsvp-te delete lsp [<lsp_name> | all]
Deleting an LSP name disassociates all configured paths with this LSP and all
configuration information for the LSP name is deleted. LSPs cannot be deleted if the
specified
has been configured as the LSP for a TLS tunnel. If you specify
<lsp_name>
the
keyword, all LSPs not associated with a TLS tunnel are deleted.
all
Adding a Path to an RSVP-TE LSP
To add a path to an RSVP-TE LSP, use the following command:
config mpls rsvp-te lsp <lsp_name> add path <path_name> {<profile_name>}
{secondary | primary}
The
must represent a configured LSP. Only one primary path and up to
<lsp_name>
two secondary paths can be added per
. The
specified defaults
<lsp_name>
<path_name>
to primary when no primary path has been configured for
and defaults to
<lsp_name>
secondary if the primary path has been previously configured for
.
<lsp_name>
You do not need to configure the primary path for an LSP. Each
added to
<path_name>
an
must be unique, but a
can be associated with multiple LSP
<lsp_name>
<path_name>
names.
MPLS Module Installation and User Guide
5-23
Advertisement
Table of Contents
