Table of Contents
Advertisement
Additional MPLS Module Support Topics
Commands that are not discussed in this chapter are supported without requiring any
modification.
General Switch Attributes
Except as described below, the MPLS module supports all of the general ExtremeWare
switch commands. Table 9-1 describes the changes to existing ExtremeWare general
switch commands to support the MPLS module.
Table 9-1: Changes to General Switch Commands
Command
clear counters
clear slot <slot number>
config slot <slot> module [f32t |
f32f | f48t | g4x | g6x | g8x | g12x
| p3c | p12c | mpls]
reboot {time <date> <time> |
cancel} {slot <slot>}
run diagnostics [normal |
extended] <slot>
show diag backplane mpls
mapping {active}
9-2
Description of Change
For the MPLS module, this command clears (zeroes) all of
the MPLS-related statistics.
This command clears a slot of a previously assigned MPLS
module.
The mpls keyword represents the MPLS module.
The slot <slot> option is added to the command to make it
possible to reboot a module in a specific slot. When you
specify this option, the command applies to the MPLS
module in the specified slot, rather than to the switch.
This command runs the MPLS module diagnostics.
This command displays diagnostic information related to the
MPLS module internal backplane switch ports. This
command also displays the external I/O port to internal
MPLS module backplane switch port mappings. This
command is only supported when the backplane
load-sharing policy mode is port-based . If the active
parameter is specified, the port mapping display is limited to
active external I/O ports only. Used in conjunction with the
diagnostic backplane utilization command, these commands
are helpful for diagnosing over-subscription problems related
to backplane I/O port switch mappings.
MPLS Module Installation and User Guide
Advertisement
Table of Contents
