Extreme Networks BlackDiamond 6800 MPLS Installation And User Manual page 117

Table 7-1: Layer-2 VPN Configuration Commands
Command
config mpls add tls-tunnel <tunnel_name>
[lsp <lsp_name> | <ipaddress> |
<host_name>] <local_vlan_name> [tls-labels
<ingress_label> <egress_label> | vcid <vcid>
{<groupid>} {from
[<local_endpoint_ipaddress> |
<local_endpoint_vlan>]}]
config mpls delete tls-tunnel [<tunnel_name>
| group <groupid> | all]
config mpls tls-tunnel vlan [<name>] mode
[hub | mesh]
show mpls tls-tunnel {summary | detail |
<tunnel_name> {detail} | vlan <vlan_name>
{detail}}
MPLS Module Installation and User Guide
Description
Adds a TLS tunnel. Specify the following:
<tunnel_name> — Used to identify the TLS
I
tunnel within the switch.
[lsp <lsp_name> | <ipaddress> |
I
<host_name>] — Identifies the peer LSR
that is the tunnel endpoint. The DNS client
must be configured to use the <host_name>.
<local_vlan_name> — Identifies the
I
Layer-2 traffic that is to be transported.
tls-labels <ingress_label>
I
<egress_label> — Identifies the innermost
labels of the tunnel stack.
<vcid> — Identifies the virtual circuit
I
identifier. The vcid value is a non-zero, 32-bit
number.
<groupid> — Identifies the logical VCID
I
group number. The groupid is a 32-bit
number. All TLS tunnels that are members of
the same TLS group ID can be withdrawn
simultaneously by specifying the groupid.
from <local_endpoint_ipaddress> |
I
<local_endpoint_vlan> — Identifies the
local endpoint of the TLS tunnel.
Deletes one or all TLS tunnels.
Configures the broadcast and unknown
packet-forwarding behavior for the specified TLS
VLAN.
Displays configuration and status information for
TLS tunnels.
Configuring MPLS Layer-2 VPNs
7-7