Extreme Networks BlackDiamond 6800 MPLS Installation And User Manual page 73

Configuration Example
Ethernet to form the OSPF backbone area and the MPLS domain. In this example, two
directly connected OSPF-disabled VLANs are shown: unc and duke. Traffic between unc
and duke follows routed paths over indirect LSPs established between LSR 1 and LSR 4.
The commands used to configure LSR 1 are described below. The remaining LSRs are
configured similarly.
The following commands configure the module types for the specific BlackDiamond
slots:
config slot 2 module f48t
config slot 3 module g8x
config slot 7 module mpls
The following command sets the maximum jumbo frame size for the switch chassis to
1600:
config jumbo-frame size 1600
The following commands create the VLANs:
create vlan vlan1
create vlan vlan2
create vlan unc
The following commands configure the VLAN IP address and assign ports participating
in each VLAN:
config vlan vlan1 ipaddress 11.0.1.1/24
config vlan vlan1 add port 3:2 untagged
config vlan vlan2 ipaddress 11.0.2.1/24
config vlan vlan2 add port 3:3 untagged
config vlan unc ipaddress 9.9.9.0/24
config vlan unc add port 2:24 untagged
The following commands enable IP packet forwarding for the specified VLANs:
enable ipforwarding vlan1
enable ipforwarding vlan2
enable ipforwarding unc
MPLS Module Installation and User Guide 4-11