Configuring Rsvp-Te On A Vlan - Extreme Networks BlackDiamond 6800 MPLS Installation And User Manual

Configuring RSVP-TE
Table 5-2: RSVP-TE Configuration Commands (continued)
Command
config mpls rsvp-te profile <profile_name>
{bandwidth <bps>} {setup-priority <priority>}
{hold-priority <priority>} {retry-timeout
<seconds>} {hop-count <number>}
{ping-interval <seconds>} {metric [<metric> |
igp-tracking} {record [enabled | disabled]}
config mpls rsvp-te vlan [<name> | all]
{hello-interval <seconds>} {refresh-time
<seconds>} {summary-refresh-time
<seconds>} {bundle-time <seconds>}
{keep-multiplier <number>}
show mpls rsvp-te {<ipaddress>} {detail}
show mpls rsvp-te lsp {<lsp_name>} {detail}
show mpls rsvp-te path {<path_name>}
{detail}
show mpls rsvp-te profile {<profile_name>}

Configuring RSVP-TE on a VLAN

To configure RSVP-TE on one or all VLANs, use the following command:
config mpls add vlan [<name> | all] {rsvp-te}
To disable RSVP-TE on a VLAN, use the following command:
config mpls delete vlan [<name> | all] {rsvp-te}
This command disables RSVP-TE on one or all VLANs. Deleting RSVP-TE causes all TE
LSPs to be released, and prevents TE LSPs from being established or accepted on the
specified VLAN.
5-16
Description
Configures RSVP-TE attributes for the specified
profile.
Configures the RSVP-TE protocol parameters for
the specified VLAN.
Displays information about the status of
RSVP-TE enabled interfaces.
Displays configuration and status information for
RSVP-TE LSPs.
Displays the configuration and status information
for MPLS RSVP-TE routed paths.
Displays all configured profile parameters for the
specified profile.
MPLS Module Installation and User Guide