Full Mesh Tls Configuration - Extreme Networks BlackDiamond 6800 MPLS Installation And User Manual

Configuring MPLS Layer-2 VPNs
The following command creates a TLS tunnel to the 11.0.1.11 network for traffic
originating from VLAN unc-wilmington:
config mpls add tls-tunnel rt40 11.0.1.11 unc-wilmington tls-labels 8f004
8f001

Full Mesh TLS Configuration

The example, shown in Figure 7-2, configures a four-node full-mesh MPLS TLS
configuration. Each LER MPLS configuration includes a TLS tunnel to every other LER.
The egress VLAN for the VPN is called ncsu. The target IP address (10.100.100.2) shown
in each TLS configuration command must be either a Router ID or Loopback VLAN
interface address.
MPLS 3
RTR ID=
11.100.100.3
ncsu
Figure 7-2: Full mesh configuration example
7-12
ncsu
VC 13
VC 23
VC 14
VC 34
ncsu
MPLS 1
RTR ID=
11.100.100.1
VC 12
MPLS 2
RTR ID=
11.100.100.2
VC 24
MPLS 4
RTR ID=
11.100.100.4
MPLS Module Installation and User Guide
ncsu
MPLS_25