VLAN Commands
Most of the VLAN commands are not directly applicable to the MPLS module. The two
exceptions are:
• The
show vlan
or disabled on the VLAN.
• Implementations of the
ipaddress
All frames received and transmitted by the MPLS module include a VLAN tag.
FDB Commands
The following FDB commands have been augmented to support the MPLS module:
• The
clear fdb
modules. If the optional
any VPN cache entry that matches the specified parameters are cleared.
• The
show fdb
the MAC address was learned.
• The
config fdb agingtime <number>
VPN MAC addresses cached on the MPLS module.
All frames received and transmitted by the MPLS module include a VLAN tag.
Basic IP Commands
The implementation of the following commands has been augmented to support the
MPLS module:
•
enable ipforwarding {vlan <name>}
•
disable ipforwarding {vlan <name>}
•
show ipconfig {vlan <name>}
•
rtlookup [<ipaddress> | <hostname>]
MPLS Module Installation and User Guide
command has been enhanced to indicate whether MPLS is enabled
config vlan delete port
commands have been augmented to support the MPLS module.
command clears the VPN source MAC address cache for all MPLS
<mac_address>
command has been augmented to display the TLS tunnel on which
and
unconfig vlan <name>
or
parameters are specified,
<vlan_name>
command can be used to age TLS Layer-2
VLAN Commands
9-5