Displaying Tls Configuration Information; Tls Vpn Configuration Examples - Extreme Networks BlackDiamond 6800 MPLS Installation And User Manual

Configuring MPLS Layer-2 VPNs
tunnel and the local TLS VLAN are treated as separate bridge ports within a single
layer 2 broadcast domain.
When the mode is configured as
received broadcast and unknown unicast packets are flooded out every port, except for
the port on which the packet was received. When the mode is configured as
TLS LSR only floods packets received from the local TLS VLAN for transmission onto
every TLS tunnel. Traffic received from a TLS tunnel is forwarded only to the local TLS
VLAN. The default mode is

Displaying TLS Configuration Information

To display TLS configuration information, use the following command:
show mpls tls-tunnel {{<tunnel_name>} {detail}} {summary}
This command displays configuration and status information for one or all TLS tunnels.
The information displayed for each tunnel includes:
• The values of all configuration parameters for the tunnel.
• The current status of the tunnel LSP.
• Transmit and receive counts in terms of packets and bytes.
If the optional
detail
the comprehensive detail format.
If the optional
summary
displayed. The summary counters displayed include the total number of active static
and dynamic TLS tunnels.

TLS VPN Configuration Examples

This section provides the following TLS configuration examples:
• Basic MPLS TLS Configuration Example
• Configuration Example Using PPP Transparent Mode
7-10
, the TLS LSR behavior is similar to a repeater. All
hub
.
mesh
keyword is specified, TLS tunnel information is displayed using
keyword is specified, summary TLS tunnel counts are
, the
mesh
MPLS Module Installation and User Guide