Configuring MPLS Layer-2 VPNs
Hub and Spoke TLS Configuration
The following example, shown in Figure 7-3 , configures a four-node hub-and-spoke
MPLS TLS configuration. The hub LER MPLS configuration includes a TLS tunnel to
every other LER. Each spoke LER MPLS configuration includes a TLS tunnel to only the
hub LER. The egress VLAN for the VPN is called ncsu. The target IP address
(10.100.100.2) shown in each TLS configuration command must be either a Router ID or
Loopback VLAN interface address.
MPLS 3
RTR ID=
11.100.100.3
ncsu
Figure 7-3: Hub and spoke configuration example
7-14
ncsu
VC 13
VC 14
ncsu
MPLS 1
RTR ID=
11.100.100.1
VC 12
MPLS 2
RTR ID=
11.100.100.2
MPLS 4
RTR ID=
11.100.100.4
MPLS Module Installation and User Guide
ncsu
MPLS_26