Configuring Route Maps; Summary Of Route Map Commands - Extreme Networks BlackDiamond 6800 MPLS Installation And User Manual

Configuring Route Maps

Route maps are used to conditionally assign accounting bin numbers to route
destinations. Route maps are used in conjunction with the match and set operations. A
match operation specifies a criteria that must be matched. A set operation specifies a
change that is made to the route when the match operation is successful.
This section describes the commands you use to configure route map policies for MPLS
modules.
This section provides information on the following topics:
• Summary of Route Map Commands on page 8-9
• Creating a Route Map on page 8-11
• Adding Entries to the Route Map on page 8-11
• Adding Statements to the Route Map Entries on page 8-11
• Route Map Operation on page 8-13

Summary of Route Map Commands

Table 8-4 describes the commands used to configure route map policies that support the
accounting function.
Table 8-4: Route Map Commands
Command
config iproute-map [ospf-intra | ospf-inter |
ospf-extern1 | ospf-extern2 | ospf | rip |
static | e-bgp | i-bgp | direct] <route-map>
| none
config route-map <route-map> <sequence
number> add goto <route-map>
MPLS Module Installation and User Guide
Description
Configures how the specified route map is to be
applied to the IP routing tables. Use none to
disassociate the route map from the routing
protocol.
Configures a route map goto statement.
Configuring Route Maps
8-9